Printah dasar dalam Configurasi router

Configurasi router

Config Terminal

1. Router>enable
Router#
2. Router#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#
3.Router(config)#interface  serial 2/0 (config Serial)
Router(config-if)#
4. Router(config-if)#no shutdown (menghidupkan)
%LINK-5-CHANGED: Interface Serial2/0, changed state to down
Router(config-if)#
5. Router(config-if)#ip address 10.10.10.1 255.255.255.252
Router(config-if)#exit

Config enternet

1. Router(config)#interface fastEthernet 0/0
Router(config-if)#
2. Router(config-if)#no shutdown (menghidupkan)enter 2x
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up

Router(config-if)#
3. Router(config-if)#ip address 192.168.1.1 255.255.255.0 (memberikan ip)
Router(config-if)#
4. Router(config-if)#exit
Router(config)#

perintah ip table

1. Router(config)#ip route 192.168.2.0 255.255.255.0 10.10.10.2
Router(config)#
2. Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console

Router#

untuk menyimpan hasil config

1. Router#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Router#

melihat config sudah tersimpan atau belum

1. Router#show running-config
kalau ada more tekan spasi